Skip to content
Troubleshooting

Why Is My Water Heater Leaking?

Where the water is coming from tells you whether it is a repairable part or a failed tank — and what to do in the first few minutes either way.

A water heater leak is not one problem. Where the water appears tells you whether you are dealing with a part, a valve, a connection or the end of the tank — and that distinction decides the cost.

First, stop the water

The valve on the cold pipe entering the top of the tank turns clockwise to close. If it has seized, close the property's main instead. On an electric unit, switch the breaker off; on a gas unit, leave the gas control alone and do not attempt to relight anything.

Do not drain the tank while the supply is still connected, and do not leave an emptied tank energised. Neither helps with the leak, and each can create a second problem.

Leak at the base of the tank

Water pooling under the tank, or rust streaks running down the jacket, means the steel shell has failed. The leak is the pressure boundary, not a fitting, and there is no field repair: patches and sealants do not hold against hot water under pressure.

This is a replacement, and the useful question becomes how quickly. A unit on a slab or in a garage is contained once the water is off. One above a finished ceiling is not.

Leak from the relief valve or its pipe

The temperature-and-pressure relief valve discharges when pressure or temperature exceeds its setting. Water from that pipe means either the valve has failed and is passing, or the system genuinely reached its limit — from a failed thermostat, a closed system without expansion control, or a backflow device that turned the plumbing into a dead end.

Replacing the valve without asking why it opened is how the same leak returns.

Leak at a fitting, valve or connection

Water at the inlet or outlet connections, at a union, or around the drain valve is a repair. Connections loosen, washers fail, and drain valves leak after years of use. These are the leaks worth fixing promptly, because a drip under a tank rusts the base and hides a shell failure later.

Leak from the top of the tank

Water appearing at the top is usually the cold inlet connection, a dielectric union, or a dip tube fitting — repairable items. It can also be condensation, which looks like a leak but is a venting or insulation problem rather than a hole.

A note on condensation

A cold tank in a humid space can sweat. Condensation appears as moisture on the outside of the tank and on the floor nearby, without a steady drip. It is worth ruling out before assuming the worst, particularly in summer and in a garage.

Leaks that are not the heater

Sometimes the water is from the pipework above, a nearby appliance, or a roof. Checking whether the moisture tracks back to a source other than the tank is a five-minute job that occasionally saves a replacement.

What happens next

Once the water is off, the source decides the path. A fitting is a repair. A relief valve is a repair plus a question. A shell is a replacement, with the permit the local building department requires.

The one thing not to do is let a shell leak run while a decision is made. It will not stop, and the damage it does to floors and ceilings usually costs more than the replacement being deferred.

Get in touch

Water on the floor right now?

Close the cold valve on the tank, or the main. Then call with where the water is appearing — that answer decides everything next.

Questions about this article

Should I drain the tank if it is leaking?

Not before the supply is off, and usually not at all without guidance. Draining a live system does not stop the leak, and an emptied tank with power on can damage an element.

Call+1 989 601 2666