Pomona's housing is a mix of mid-century streets and newer infill, and tankless comes up in both for the same reason: floor space is worth more than the tank that occupies it. Whether the conversion works depends on three things about the building.
One: can the gas line carry it
Conversions live or die here. Stored hot water needs a gentle burner; instant hot water needs a big one, several times the input, and the whole supply chain behind it (pipe, meter, regulator) must be able to feed that.
When it cannot, the project grows a gas upgrade: new pipe through a wall, a chase or a crawlspace. Homeowners are usually surprised at this line item, and it is the one that decides whether the conversion is worth doing.
Two: where does the vent go
The old flue stays with the old tank. Its replacement is Category III or IV vent, stainless or polypropylene, held to the distances its listing requires and, where the unit condenses, paired with a drain line that falls to a discharge point.
Most homes here terminate through a side wall, which brings its own geometry: offsets from operable windows, doors, air intakes and the property line. A wall shared with a neighbour is a measurement and a conversation at once.
Three: who descales it
Hard water is the regional norm, and a tankless heat exchanger is where those minerals end up. Descaling, which means circulating a mild acid through the unit, keeps the exchanger alive, and the inlet filter needs cleaning too.
If nobody in the household will do that on a schedule, the honest recommendation is a tank. A tankless unit that is never descaled fails earlier and more expensively than the tank it replaced.
Sizing, honestly
Count what runs at once: two showers, a dishwasher, a laundry. Then allow for winter, when the incoming water is colder and the same flow needs more energy from the same unit.
Where demand is high, two staged units usually beat one large one, and they give the household a working heater while one is being serviced.
The permit
Pomona permits water-heater work through its building division, and since 1 January 2026 the 2025 code editions apply, adopted through City Code § 74-31. A conversion that changes the vent and the gas line is a larger scope than a same-size swap, and the counter confirms how the job is classified.
Permit fees are set by council resolution rather than in the code, so the current schedule is what counts. Simple residential work is handled at the counter; anything with structural or seismic content takes longer.
When a tank is the better answer
Where the gas service is marginal, where the vent would mean opening a finished wall, or where the unit will not be maintained. A modern tank, strapped and permitted, asks less of its owner and costs less to install. That is worth saying plainly rather than selling past it.