Richfields' houses are compact by valley standards, and an installation here is often a question of fitting a capable unit into a small space rather than finding the biggest one available.
Sizing for a small house
A small house is not a small load. Two bathrooms in sequence, plus a laundry and a dishwasher, can exhaust a modest tank when everyone is getting ready at once. Recovery — how fast the unit reheats — matters more than the stored volume in that situation.
A tankless unit takes the opposite approach: no storage, so the rating that matters is how much water it can heat at the incoming temperature. In winter that number drops, and a small unit sized in July can be underwhelming in December.
Gas, venting, space
A gas tank needs a flue sized for it with proper clearances, plus combustion air. A closet without a louvered door or a dedicated air supply is a design problem, not a detail.
A tankless unit needs a larger gas supply and a different vent class (stainless or polypropylene), with tighter clearances and, on condensing models, a condensate drain.
A garage installation brings a height requirement: any source of ignition has to sit 18 in. or more off the slab, or the unit must live in its own compartment vented from outdoors.
The permit and the counter
Richfields is inside Placentia, so the Building Division issues the permit. Water heaters are on the city's counter list, issued without plan check after planning and zoning clearance.
The paperwork the counter asks for is specific, and it is worth gathering before the visit rather than during it: a contractor's identification, state contractor card and workers' compensation verification unless working alone, and the city business licence number. An agent applying on someone's behalf needs a notarised authorisation.
Work started without that permit carries a penalty equal to the full fee, which is the city's way of insisting the order is permit first.
What the inspection checks
Strapping in the upper and lower thirds with clearance above the controls. The vent and its cap. The relief valve and where its discharge goes. The gas connection and its sediment trap. Access and working space around the unit, and clearances to anything combustible.
None of that is optional, and each item is checkable before the inspection rather than after it.
Living with the result
Scale is the long-term issue on this water. A flush routine and an anode-rod check from the first year are what keep a new tank near the life its label suggests. On a supply this hard, they are not a luxury.
One visit, usually
A like-for-like installation in an existing location is generally a single visit plus the inspection. A change of fuel, type or location adds gas, electrical or venting work, and the schedule follows whichever trade takes longest.