Most replacements in Richfields are the same-size kind: a tank that has reached the end of its life, swapped for a comparable unit in the same spot, with Placentia's permit and inspection attached.
Confirming the end
Water under the tank is the clearest signal. Rust streaks down the jacket say the same thing a season earlier, and a bulge says it is happening now. In all three cases the pressure boundary has failed, and no sealant restores it.
The less obvious ending is a tank that keeps asking for money. Two or three repairs in a couple of heating seasons is a pattern, and once the repair cost approaches a meaningful share of a new unit, the arithmetic has already answered.
What the swap involves
Water and fuel off, tank drained, lines and vent disconnected, unit removed, new unit set, reconnected, strapped, filled, and the relief discharge confirmed to run clear. Then the inspection.
The peripherals are where a swap slows down: a shut-off that will not close, a connector seized to the nipple, a vent connector rusted at the collar, or a closet where the new unit is an inch too tall for the flue.
The permit, and why the order matters
Placentia issues water heater permits at the counter, without plan check, once planning and zoning clearance is in hand. The city charges a penalty equal to the full fee when work starts without one.
So the sequence is permit, install, inspect — not install, then arrange paperwork. An unpermitted replacement also skips the inspection, and that gap tends to surface at a sale, a refinance or an insurance claim.
What is on the inspector's list
Straps top and bottom, with the upper one clear of the controls by 4 in. The vent and cap. The relief valve's discharge line, correctly sized and routed outside. The gas connection with its sediment trap. Access and working space, and clearances to combustibles.
Those are the same items a homeowner can check on an existing unit, which makes them a useful thing to know before the old tank comes out.
The new tank and the same water
Scale does not care that the unit is new. Flushing on a schedule and replacing the anode rod when it is spent are what separate a replacement that lasts from one that repeats the previous cycle early — and neither requires anyone's permission.
If the tank is leaking today
Close the cold inlet valve at the top of the tank, or the main if that valve will not turn. Put something under the leak if it is at a fitting; if it is the shell, no container will keep up, so move what is nearby and call. The water going off is what stops the damage.